![]() A fully-charged 12-volt battery, allowed to rest for a few hours (or days) with no load being drawn from it (or charge going to it), will balance out its charge and measure about 12.6 volts between. Twelve volts is just a nominal, convenient term used to distinguish one battery from another. You need to let it settle (no electrical activity) for at least 2 days. A 12-volt battery is not a 12-volt battery. However, as I mentioned before, an OCV reading 30 minutes after removing batteries from the charger won't give you an accurate figure. A battery holding 100% of its rated capacity would read 6.6 V. With the 6V battery, an OCV reading of 6.4 volts indicates it has a stored charge of ~4/6, or 67% of its rated Ah capacity. A battery holding 100% of its rated capacity would read 13.2 V. In the case of a "12V" Lead-Acid battery, an OCV reading of 12.7 volts indicates it has a stored charge of about 7/12, or 58% of its rated Ah capacity. That voltage will indicate roughly the percentage of charge, compared to the rated Ah capacity of the battery. I had a customer who had a 12 volt John Deere back hole tractor, the battery and charger were. You also want to check the terminals inside the connectors battery side and vehicle side. Check 6 volt or 12 volt batteries 6 volt fully charged should read 6 plus volts 12 volt should read 12volts plus. Whatever voltage the batteries settle down to after 30 min, they will probably settle to a lower voltage after ~5 days (of no electrical activity). Step 2: Testing the Batteries and Connections. That might be because of the charger itself, or the charging method or it might be because the batteries are old or hard-used and just won't hold a full charge any more. Your charging arrangement isn't charging your 12V and 6V batteries up to anywhere near their full rated capacity. You must observe and manually disconnect the charger.ĭo not connect the small lightbulb in series because the 12volt charger will sense too much resistance and then indicate a fault after two minutes. Then the 12 volt battery will settle to 12.7 volts after 30 minutes.Ī 6 volt battery connected to a 12 volt charger with the small 12volt light WILL NOT cut out because you want a fully charged 6 volt battery to settle to 6.4 volts. The small light creates a drain and the charger continues to charge that cell.Ī 12 volt battery connected to a 12 volt charger will cut out at 14.6 volts. The cell on the + side will stop bubbling first as the 6 volt battery reaches full charge, then the middle cell will stop bubbling, then the cell on the - side will just barely be bubbling when fully charged. Unscrew the three caps on the 6 volt battery and observe the bubbles of hydrogen gas leaving the electrolyte from each cell. Blu Batterie Snc offers a wide range of battery chargers, capable of satisfying any type of request You can buy from simple manual charger models to those. Voltage at battery will be 6.7 to 7.02 volts. Now connect a 12 volt charger to the 6 volt battery. ![]() Connect a 12 volt taillight, turn signal or any small 12 volt lightbulb to your 6 volt battery. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |